MG & Rover - XPower Forums banner
1 - 9 of 9 Posts

·
Registered
Joined
·
398 Posts
Discussion Starter · #1 ·
Right, this was soldered in almost a month ago now

work fine etc, then the right hand side of lights flicker and come on and off as they see fit

i.e most of the time i dont get either the red or the green light AT ALL!!

A slight bit of pressure on the accelerator make the lights flicker or go off completely

Now, also worth mentioning the lights should be on with ignition on and also for a while after the ignition turned off

The right hand set of lights do not always do what they should do

Would this be a dodgy solder or a dodgy connection, have no issues as far as power in concerned though
 

·
Registered
Joined
·
398 Posts
Discussion Starter · #3 ·
Yup, worked fine for about 2 weeks then started to do a wobbly!

It's only since one of my tools got stuck in the throttle cable/housing whilst driving (oooops)

everything looks fine etc, just flickering lights etc, seems really strange
 

·
Registered
Joined
·
398 Posts
Discussion Starter · #7 ·
My mate did it for me, would've preferred more solder on the joints for me but...

I don't know anyone that can, no
 

·
Registered
Joined
·
3,492 Posts
How to solder

Worth learning, it isn't difficult and means that connections are as one peice rather than two peices touching.

Where was your tool before it got caught up?
Could it have interfered with the connections for the viz indicator.
 

·
Registered
Joined
·
398 Posts
Discussion Starter · #9 ·
Did think they might of done but it's all wraped up in Tape and in that cable shield stuff so prob not

Confused to be honest, I dunno....
 
1 - 9 of 9 Posts
Top