MG & Rover - XPower Forums banner

1 - 8 of 8 Posts

·
Ahhh. It's good to be back.....
Joined
·
1,454 Posts
Discussion Starter #1
The resevoir in my Sheddist clutch kit is very low. Can I just top it up with my dot whatever brake fluid or do I have to bleed it all and start again. If it's the latter can anyone tell me an easy way?
 

·
Premium Member
Joined
·
7,145 Posts
A top up will be fine.
 

·
Elegantly Wasted
Joined
·
286 Posts
Yep just a top up will be fine:)

But if you want to give it a flush through, just get a one man bleed kit. Fit it on bleed nipple on slave and bleed away, the fluid does go pretty discoloured and i found a flush through made a difference. It doesn't take long either:)
 

·
Ahhh. It's good to be back.....
Joined
·
1,454 Posts
Discussion Starter #4
Lovely ta - just topped it up.
 

·
R.I.P [The Red Zed] MG ZS 180
Joined
·
19,410 Posts
There we go then :)
 

·
Registered
Joined
·
43 Posts
Re: Sheddist clutch kit

Would anyone that has fitted the sheddist clutch kit have any part numbers or bore sizes of the Civic master and slave units that are used. I have pm'd Sheddist several times for the supply of a kit so far no luck, so I thought I would attempt to make the kit myself if I had the Civic master and slave info.
Thanks Cartoys
 

·
Ahhh. It's good to be back.....
Joined
·
1,454 Posts
Discussion Starter #7
I'm ever so sorry - can't help there. Sheddist works abroad a lot so he won't be ignoring you he'll just be busy.
 
1 - 8 of 8 Posts
Top