MG & Rover - XPower Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2,442 Posts
Assuming you don't have access to a press which makes the job really easy, one method I used which worked was to burn the rubber part of the bush, then cut the metal shell with a hacksaw, brutal but effective.
 

·
Registered
Joined
·
2,442 Posts
Yes inside to out, cutting it wasn't to bad, iirc I didn't need to cut all the way through it, just enough to weaken it a bit, then hit it with a punch and hammer, btw if you are fitting poly bushes you will need to re-use the metal shells so cutting them wouldn't be good.
 
1 - 2 of 2 Posts
Top