MG & Rover - XPower Forums banner
1 - 8 of 8 Posts

·
Registered
Joined
·
197 Posts
Discussion Starter · #1 ·
Hi all

Tonight whilst driving home, my car felt like there was a lack of power after changing gear. Not going very fast, just normal driving. It felt like lifting off the accelerator.

Just did an odb fault code check and got a P0152 02 Sensor Circuit High Voltage (Bank 2 Sensor 1).

Not sure if bank 2 is rear or front of the engine.
Funny this should happen after filling up too.

Cheers
Simon
 

·
Registered
Joined
·
1,194 Posts
It wasnt p0172, that is bank 1. it was p0175 then changed to p0135. anyway i changed the lambda at the front. TBH i wasnt sure which one it was but cleared the fault and hs been fine since. heres a link if its any use?

http://forums.xpowerforums.com/showthread.php?t=55720&highlight=p0172

i know 02's ain't a new thing. it was only newish cars that have limp home mode that were having to call out the RAC/AA. we're alright in our old rovers lol.
 

·
Registered
Joined
·
197 Posts
Discussion Starter · #8 ·
Thanks for the replies. I take it the inlet manifold has to come off to replace the sensor. Would plugging it make the engine run better, surely that would trigger another fault?
 
1 - 8 of 8 Posts
Top