MG & Rover - XPower Forums banner
1 - 5 of 5 Posts

34 Posts
Discussion Starter · #1 ·
Here is the Piston heads link to my car...

For sale is my well looked after MG ZS 180 Hatchback in Anthracite. Its has the full 180 bodykit, including 17 inch 'straights' and the low level, more subtle boot spoiler.

MOT till 28th Feb 2012
TAX till end of August 2011

The car has just tipped over 48,000 geniune miles and is in use daily so will go up slightly. I have plenty of service history to prove this milage. The engine itself runs very quietly and smoothly which is typical of the KV6 engine.

Exterior condition is virtually spotless, its a 10 year old car so there are a couple of light (and i mean light blemishes to paint) but im only being picky here. The paintwork is still in very good condition.. No dents or scrapes. Alloys again are in good condition, minor kerbing on the front wheels, very light kerbing on the rears. I had a stainless steel powerflow exhaust fitted earlier in the year as the standard one was blowing. It looks great and sounds really good, its not loud either. This exhaust also has a lifetime warranty.

The interior is spotless. The seats are the half leather red 'monaco' interior. No rip, tears, and no signs of wear either! I've even fitted matching rear head rests to compliment the rest of the interior. Red floor mats are also fitted. I have upgraded the front speakers as the standard ones were naff. It comes with the original stereo head unit, though while it looks basic (its still sporting a tape cassette deck - what are they??) its also linked up to a 6 disk CD changer hiding in the boot! I'll even throw in one of them tape adaptors which allows you to listen to your ipod/mp3 player through the tape deck.

This car has been well cared for by me, i am a member of an MG ZS owners club and have always taken pride in showing off one of the last remaining 'proper' MG's.

List of parts changed recently include

- New tyres front and rear
- New disks and pads front and rear
- Regassed air conditioning
- Stainless steel exhaust
- Clutch hydraulics

More items also fitted and i have lots of service history, MOTs, receipts to prove this.

Thank you for taking the time to look at the advert. I'm sure the first to look will buy! Its a great example of a ZS180.

Im looking for 1250 pounds. Or nearest offer.

68 Posts
What you gonna replace it with mate?
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.