MG & Rover - XPower Forums banner
1 - 5 of 5 Posts

·
often cruized never beaten......
Joined
·
239 Posts
Discussion Starter · #1 ·
guys i havent got a clue which one is which. as im struggling to adjust the biting point on a sheddist kit.:confused:
 

·
MG ZS 180 MGB GT V8
Joined
·
159 Posts
The master cylinder is the one attached to the foot pedal and the slave cylinder is at the clutch/engine end of the hydraulic pipe. The bite point is adjusted by turning the pushrod between the pedal and master cylinder in or out as appropriate.
 

·
Registered
Joined
·
3,703 Posts
You may have to adjust the pedal stop by using a longer bolt and spacing it out with and extra nut threaded onthere.
 

·
Registered
Joined
·
1,539 Posts
Is it bad I thought this post was about hard drives at first?
Yes because master/slave hasn't been relevant since IDE drives on win 98? Unless I am wrong. "Cable select", oh dear.

Gaffa - come and get these wheels and I'll show you how to adjust, on my car if needs be.
 
1 - 5 of 5 Posts
Top