MG & Rover - XPower Forums banner
1 - 20 of 27 Posts

·
MG XPower.
Joined
·
2,119 Posts
Discussion Starter · #1 ·
12 months ago I fitted Fog Lights to my TF. At the time I did not want them wired(only for show) But I have decided to wire them so that they work. Where can I get the connector that goes into the Fog Light Bulb?
 

·
Administrator
Joined
·
10,642 Posts
Can you post up a pic of the bulbholder connection?

I think I might know of a source.
 

·
MG XPower.
Joined
·
2,119 Posts
Discussion Starter · #4 ·
The details on the bulb/holder are:-
OSRAM H11 12v 55w 64211 DOT

 

·
Administrator
Joined
·
10,642 Posts
Yep, I reckon I can get you a couple of connectors.

Will need to ask my contacts this week - can you bear with me?
 

·
MG XPower.
Joined
·
2,119 Posts
Discussion Starter · #6 ·
Gas-Axe said:
Yep, I reckon I can get you a couple of connectors.

Will need to ask my contacts this week - can you bear with me?
Yes, there is no rush.
Thanks for your help and time.

Gaz.
 

·
Registered
Joined
·
12 Posts
The proper wiring loom is NLA. I have been trying to get one for ages but with no success, either new or S/H from a breaker.

Fog lamps are standard for several MGR models so lamp connectors may be easy to find S/H but the rest of the loom is unique to the TF.

I have had to make up my own loom.
 

·
MG XPower.
Joined
·
2,119 Posts
Discussion Starter · #8 ·
jinglepete said:
The proper wiring loom is NLA. I have been trying to get one for ages but with no success, either new or S/H from a breaker.

Fog lamps are standard for several MGR models so lamp connectors may be easy to find S/H but the rest of the loom is unique to the TF.

I have had to make up my own loom.
Where did you get the connectors from?
 

·
Administrator
Joined
·
10,642 Posts
Sheesh, I've forgotten these! I will make a phone call tonight.
 

·
Administrator
Joined
·
10,642 Posts
I have two - PM me with an address to send them to!
 

·
Administrator
Joined
·
10,642 Posts
PM recieved - you should get them Tuesday! Depends upon the Postal Service!
 

·
Administrator
Joined
·
10,642 Posts
Bottom right, second row up, 2 cavity connectors are what you're after.....

 

·
Administrator
Joined
·
10,642 Posts
Let me know if you have any luck sourcing the Wurth connectors.

I might have something out in the workshop that might work too. No promises though......
 

·
Administrator
Joined
·
10,642 Posts
Found this connector, but looking at your picture the pin orientation is 90 degrees out.....

 
1 - 20 of 27 Posts
Top