MG & Rover - XPower Forums banner
1 - 9 of 9 Posts

·
Registered
Joined
·
200 Posts
Discussion Starter · #1 ·
Rights guys, I have stuck my fault code reader on the car and I am getting P0122 (TPS - Switch A Circuit Low Input) and P0141 (O2 Sensor - Heater Circuit Malfunction - Bank 1 Sensor 2)
What do I need to do to sort this, anyone know??
 

·
R.I.P [The Red Zed] MG ZS 180
Joined
·
19,410 Posts

·
Registered
Joined
·
200 Posts
Discussion Starter · #3 ·
That's brilliant mate, was unaware of that site and I couldn't find much info elsewhere. Nice one pal, thanks!
 

·
R.I.P [The Red Zed] MG ZS 180
Joined
·
19,410 Posts
If its anything to do with sensors you could try cleaning them.

Or try the search facility on the forum as i am sure there will have been others with these fault codes.
 

·
R.I.P [The Red Zed] MG ZS 180
Joined
·
19,410 Posts

·
R.I.P [The Red Zed] MG ZS 180
Joined
·
19,410 Posts
That i have no idea of:)
 

·
Registered
Joined
·
200 Posts
Discussion Starter · #9 ·
sensor 2 is post cat.
Do you have a MIL eliminator?
Nope, does the post cat one have no ill affects then if not running properly. The eml isn't on, only came up when I plugged in fault code reader so if it doesn't affect anything I will happily ignore it ;)
 
1 - 9 of 9 Posts
Top