MG & Rover - XPower Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
Does anyone know the part no / where I can get the connector at the end of the breather pipe?

The one at the throttle body.

I've just replaced a bodged fix of the breather pipes only to find that the little red connector is missing. The connector I'm talking about has to be pushed in to allow the removal of the breather pipe.

Can anyone see a problem with using sealer instead?

Thanks again!
 

·
Administrator
Joined
·
10,642 Posts
You could use a dab of silicone sealant to hold it in otherwise the little red bit from any K series inlet manifold that secures the brake servo hose connection will do.
 
1 - 2 of 2 Posts
Top