MG & Rover - XPower Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter · #1 ·
Hi all,

I have a 2003 MG ZT cdti 115+, the clutch has just been replaced and bled (correctly?). The clutch pedal only travels around 1/3 of the way back up after you take your foot off, I have to pull the pedal up with the toe section of my shoe!

But being a new clutch it still bites and drives fine, there just seems to be no back pressure pushing the pedal back up. The pedal feels fine to push down on, not hard and there is the normal resistance when pushing the pedal down.

What could this be?

Thanks

Joe
 

·
Banned
Joined
·
2,861 Posts
did they replace the slave cylinder/release bearing?Could have air in master cylinder still or it is also knackerd. did they top the reservoir up ? its located INSIDE the car above the clutch pedal.
George
 

·
Registered
Joined
·
21 Posts
Discussion Starter · #3 ·
I have had nothing but trouble with the clutch in this car, everything has been replaced and bled. Has has in the last 1000 miles:
New slave
New master
New clutch
All bled and fitted by (experts?) hmm

Any ideas?
 
1 - 3 of 3 Posts
Top