MG & Rover - XPower Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,194 Posts
Discussion Starter · #1 ·
Would anyone be able to help me out, I need an outline of the exhaust bracket that attaches the rear bank manifold under the engine. I want to jet cut one from a bit of titanium scrap I’ve had knocking around for ages. If you have one handy and could maybe trace the outline including the hole positions I should be able to convert to DXF and whip one off. An addition bracket will be made for whoever can supply the required drawing.

Thanks in anticipation of your assistance.

 
1 - 1 of 1 Posts
Top